[Jun-2022] NS0-527 Free PDF from PassTestking [Q53-Q77]

NEW QUESTION 53
Click the Exhibit button.

Referring to the exhibit, which three would be used to configure the three-way Data Center Disaster Recovery topology replication schedules? (Choose three.)

NEW QUESTION 54
A customer wants to maintain a single copy for both disaster recovery and backup on a secondary system.
Which SnapMirror policy andrelationship type should be used?

NEW QUESTION 55
After deploying an ONTAP Select 2 node HA cluster at a remote site, you successfully perform manual takeover and giveback before placing the cluster into production. After the cluster runs in production for a week, you notice that you can no longer perform a manual takeover.
In this scenario, what are two causes of this problem? (Choose two.)

NEW QUESTION 56
You want to back up a critical Oracle database that resides on a LUN on the NetApp storage system. You decide that a Snapshot copy is the most efficient way to back up the database. You cannot afford to create any down time for the database.
What must you do to ensure that the data in the database is consistent when you create the Snapshot copy?

NEW QUESTION 57
Click the Exhibit button.

You want to restore a file from the engineering volume that is shown in the exhibit. When you click Restore in OnCommand Unified Manager, there are no files available to restore.
Referring to the exhibit, what caused this problem?

NEW QUESTION 58
Click the Exhibit button.

You have been receiving the lag status error notifications shown in the exhibit.
What must you do to correct this problem?

NEW QUESTION 59
What does the metrocluster configuration-settings interface create command do?

NEW QUESTION 60
Click the Exhibit button.

A customer is interested in using SnapCenter tosupport Snapshot copies with their Oracle DB. They virtualized their environment but do not have any block protocols available.
In this solution, which protocol shown in the exhibit is supported?

NEW QUESTION 61
A volume has been filled completely by active data and Snapshot copies.
What must you do to make the volume writable again?

NEW QUESTION 62
You have successfully deployed a primary and a secondary ONTAP cluster. You want to set up an intercluster SnapMirror relationship between your primary and secondary sites.
In this scenario, which two actions are required before accomplishing this task? (Choose two.)

NEW QUESTION 63
The volume efficiency modify command, enables which three storage efficiency technologies when applied to a FlexVol volume? (Choose three.)

NEW QUESTION 64
A customer wants to monitor the current utilization of storage capacity to ensure storage availability. They decide to implement quotas on some volumes.
What are three types of quotas that would satisfy the customer’s requirement? (Choose three.)

NEW QUESTION 65
In clustered Data ONTAP, you are creating MirrorAndVault XDP relationships between existing primary and secondary volumes. The Snapshot copy policies have already been created and assigned. The peering is already established and functional.
In clustered Data ONTAP, which three actions should be taken? (Choose three.)

NEW QUESTION 66
Which NetApp technology helps to protect against ransomware attacks?

NEW QUESTION 67
Which two tools would you use toverify that an Oracle database has an application-consistent snapshot taken?
(Choose two.)

NEW QUESTION 68
You are asked to verify that data stored in your disaster recovery site can be restored and is viable. Currently, you have a NetApp SnapMirror relationship with a MirrorAllSnaps policy type that is enabled and is updating frequently.
What would be a nondisruptive method to carry out a detailed validation of your disaster-recovery strategy?

NEW QUESTION 69
You have deployed the DP_Optimized (DPO) license on the destination cluster to support a high number of volumes and peer relationships for setting up data protection with multiple sourceclusters. You want to obtain a list of unprotected volumes on the source cluster and protect them.
Which two management tools would be used to accomplish this task? (Choose two.)

NEW QUESTION 70
The customer has experienced a disaster at their primary data center. You have implemented a SnapMirror relationship to meet their needs. You have performed the steps to make the destination volume read/write accessible to the clients.
Which three actions should your considerdoing while the customer makes the necessary repairs to their data center? (Choose three.)

NEW QUESTION 71
A client has a FlexVol volume that is 10 TB in size and is nearly full. The volume has a Snapshot reserve of
5%, that is currently utilized at 120%. They have chosen to enable ONTAP to automatically delete the oldest Snapshot copies with a volume threshold trigger in order to free space within the volume when it becomes necessary.
In this scenario, what amount of space would be made available to the client, without additional intervention?

NEW QUESTION 72
Exhibit:

Referring to the exhibit, You have a MetroCluster IP solution that uses Cisco Nexus 3232C back-end switches for a maximum ISL distance of 700 km. What is the maximum round trip ISL latency that is supported in this scenario?

NEW QUESTION 73
Using SnapCenter 4.0, you are restoring a virtual machine.
Which additional tool would be used to monitor the restore?

NEW QUESTION 74
A volume has been filled completely by active data and Snapshot copies.
What must you do to make the volume writable again?

NEW QUESTION 75
You want to implement a cross-site disaster recovery solution for a mission critical business application that can provide a near zero recovery time objective (RTO) and recovery point objective (RPO). You want to use the existing high-bandwidth dedicated Ethernet and IP infrastructure for replication between the two sites.
Which NetApp solution meets these business requirements?

NEW QUESTION 76
Click the Exhibit button.

You need to verify that you have a 10 Gb path between two clusters for SnapMirror traffic. Referring to the exhibit, how fast is the network path between the clusters?

NEW QUESTION 77
Your customer needs to activate a destination SVM DR following a disaster.
In this situation, which two actions should be performed? (Choose two.)