[Apr-2023 Newly Released] Pass NCM-MCI-5.20 Exam – Real Questions & Answers [Q32-Q50]

QUESTION 32
An administrator has a custom backup application that requires a 2TB disk and runs in Windows. Throughput is considerably lower than expected.
The application was installed on a VM with the following configuration:
* Four vCPUs with one core/vCPU
* 4GB of Memory
* One 50GB vDisk for the Windows installation
* One 2TB vDisk for the application
What is the recommended configuration change to improve throughput?

QUESTION 33
An administrator migrates a VM onto a new Nutanix cluster. After the migration, the administrator observes the following conditions:
* Cluster memory utilization: 64%
* Cluster CPU utilization: 19%
* Cluster storage utilization: 32%
* Average VM CPU utilization: 25%
* Average VM CPU ready%: 24%
* Average VM memory utilization: 60%
Which two changes should the administrator make to improve VM performance? (Choose two.)

QUESTION 34
Which Component Allows you to pair sites for disaster Recovery Policy Creation Using Nutanix Leap?

QUESTION 35
An administrator inherits a new Nutanix environment and logs in to a CVM to check the network configuration. The configuration is as follows:

Which action should the administrator take to improve network performance?

QUESTION 36
An administrator is monitoring the Nutanix v5.15-based AOS cluster performance logs and notices that a SQL server VM is greatly exceeding its intended maximum IOPS. The administrator has confirmed that a QoS policy was previously created for the group of VMs this server is a member of.
What are two reasons that this VM would exceed its maximum configured IOPS from the QoS Policy? (Choose two.)

QUESTION 37
An administrator needs to make sure an RF2 cluster can survive a complete rack failure without negatively effecting workload performance. The current cluster configuration consists of the following:
* 30 nodes: distributed 10 nodes per rack across three 42U rack
* Each nodes is configured with 40TB usable storage all flash (Cluster Total 1.2 PB Usable)
* Current cluster utilization is 900TB storage
Which configuration changes should be made to make sure that the cluster meets the requirements?

QUESTION 38
An administrator needs to create and start five new VMs for a Data Analytics Project (OLAP). The VM Profile is as follows:
* vCPU:4
* vRAM: 64 GB
* vDisk: 1.5 TB
Each of the four nodes of the Nutanix cluster has the following:
* 24 vCPU. 20% overall usage
* 192 GB RAM, 60% overall usage
* 2xl920GBSSD
* 4x 2 TB HDD
At cluster level, there is a single RF2 container that is 30% utilized and has an extent store capacity of 13.5 TB.
Which component requires administrator attention?

QUESTION 39
Which Windows technology does AHV support to prevent authentication theft?

QUESTION 40
An administrator is deploying a three-tier application on a Nutanix Enterprise Cloud consisting of web, application, and database VMs. Traffic between the servers must be limited to specific services/ports. There is an application layer firewall VM deployed on one host in the cluster.
In which way should the administrator meet this requirement?

QUESTION 41
An administrator learns that some security settings in a cluster have been changed. The environment is out of compliance with required policies.
Which function should be used to revert any settings that have changed from the defaults and prevent further violations?

QUESTION 42
Refer to the exhibit.
An administrator logged into Prism Element, notices the following in the home dashboard, and showing the exhibit.
Which action should the administrator take next?

QUESTION 43
Refer to the exhibit.

A Nutanix host is connected as shown in the exhibit with br0-up set to active/backup. Physical Switch 1 experiences a power outage causing br0-up to failover to using eth2. The CVM and host become inaccessible. User VMs restart on other hosts in the cluster, which causes a disruption to those VMs.
Which configuration issue likely caused this outage?

QUESTION 44
A company’s Security team has requested that all IT resources be hardnened.
What should an administrator do to increase the security of the ntuanix environment ?

QUESTION 45
An administrator is deploying Nutanix Files 3.5 and needs to configure the sizing of the FSVMs for an increased number of concurrent SMB connections over the default 750.
What should the administrator do?

QUESTION 46
An administrator is performing a set of routine checks and notes that Prism Central is running with 4 vCPUs and 21 GB RAM. The organizations environment is based on two Nutanix clusters with 170 VMs plus a Legacy vSphere infrastructure. No manual changes have been done on Prism Central VM.
Which configuration justifies the current Prism Central configuration?

QUESTION 47
An administrator is supporting a business critical environment and deploys metro availability to achieve a zero data loss configuration. The two clusters are connected by a 1GbE connection. A new workload is going to be deployed to this cluster. This workload requires a sustained 150MB/S of write throughput and 20MB/s of read throughput.
Which change must be made to deploy the workload successfully on this cluster?

QUESTION 48
A system administrator needs to shut down an AHV node in a Nutanix cluster without causing service disruption. The administrator checks data resiliency and verifies that the cluster can tolerate a node down.
Which three steps should the administrator perform next? (Choose three.)

QUESTION 49
A guest VM is reported to have poor storage performance. It has an I/O profile of 80% read. 20% write, and the HDDs form more than 50% of the read source.
What should an administrator do to resolve this issue?

QUESTION 50
An administrator is using Nutanix Move to migrate a Windows VM from ESXi to AHV. Automated guest preparation is failing with an error:
Account has UAC enabled error
The administrator is using the local built-in administrator account for the Windows VM Admin approval mode must remain enabled.
What should the administrator do to continue with the migration with Nutanix Move?