Get Instant Access of 100% REAL NSE7_SDW-7.0 DUMP Pass Your Exam Easily [Q32-Q47]

Rate this post

Get Instant Access of 100% REAL NSE7_SDW-7.0 DUMP Pass Your Exam Easily

NSE7_SDW-7.0 Free Exam Questions with Quality Guaranteed

NEW QUESTION 32
Refer to the exhibits.
Exhibit A –

Exhibit B –

Exhibit A shows a site-to-site topology between two FortiGate devices: branch1_fgt and dc1_fgt. Exhibit B shows the system global and system settings configuration on dc1_fgt.
When branch1_client establishes a connection to dc1_host, the administrator observes that, on dc1_fgt, the reply traffic is routed over T_INET_0_0, even though T_INET_1_0 is the preferredmember in the matching SD-WAN rule.
Based on the information shown in the exhibits, what configuration change must be made on dc1_fgt so dc1_fgt routes the reply traffic over T_INET_1_0?

Enable auxiliary-session under config system settings.

Disable tp-session-without-syn under config system settings.

Enable snat-route-change under config system global.

Disable allow-subnet-overlap under config system settings.

Explanation
Controlling return path with auxiliary session When multiple incoming or outgoing interfaces are used in ECMP or for load balancing, changes to routing, incoming, or return traffic interfaces impacts how an existing sessions handles the traffic. Auxiliary sessions can be used to handle these changes to traffic patterns.https://docs.fortinet.com/document/fortigate/7.0.11/administration-guide/14295/controlling-return-path-

NEW QUESTION 33
Refer to the exhibit.

Which statement explains the output shown in the exhibit?

FortiGate performed standard FIB routing on the session.

FortiGate will not re-evaluate the session following a firewall policy change.

FortiGate used 192.2.0.1 as the gateway for the original direction of the traffic.

FortiGate must re-evaluate the session due to routing change.

NEW QUESTION 34
Refer to the exhibits.

Exhibit B –

Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?

port1 is assigned a manual IP address.

port1 is referenced in a firewall policy.

port2 is referenced in a static route.

port1 and port2 are not administratively down.

NEW QUESTION 35
Refer to the exhibits.
Exhibit A

Exhibit B

Exhibit A shows an SD-WAN event log and exhibit B shows the member status and the SD-WAN rule configuration.
Based on the exhibits, which two statements are correct? (Choose two.)

FortiGate updated the outgoing interface list on the rule so it prefers port2.

Port2 has the highest member priority.

Port2 has a lower latency than port1.

SD-WAN rule ID 1 is set to lowest cost (SLA) mode.

NEW QUESTION 36
Refer to the exhibit.

The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device? (Choose two.)

Each BGP route is three hops away from the destination.

ibgp-multipath is disabled.

additional-path is enabled.

You can run the get router info routing-table database command to display the additional paths.

NEW QUESTION 37
Which two statements about the SD-WAN zone configuration are true? (Choose two.)

The service-sla-tie-break setting enables you to configure preferred member selection based on the best route to the destination.

You can delete the default zones.

The default zones are virtual-wan-link and SASE.

An SD-WAN member can belong to two or more zones.

NEW QUESTION 38
What are two common use cases for remote internet access (RIA)? (Choose two.)

Provide direct internet access on spokes

Provide internet access through the hub

Centralize security inspection on the hub

Provide thorough inspection on spokes

NEW QUESTION 39
Refer to the exhibit.

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2.
Which two configuration settings are required for Toronto and London spokes to establish an ADVPN shortcut? (Choose two.)

On the hubs, auto-discovery-sender must be enabled on the IPsec VPNs to spokes.

On the spokes, auto-discovery-receiver must be enabled on the IPsec VPN to the hub.

auto-discovery-forwarder must be enabled on all IPsec VPNs.

On the hubs, net-device must be enabled on all IPsec VPNs.

NEW QUESTION 40
What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )

It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.

It improves SD-WAN performance on the managed FortiGate devices.

It sends probe signals as health checks to the beacon servers on behalf of FortiGate.

It acts as a policy compliance entity to review all managed FortiGate devices.

It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.

NEW QUESTION 41
What is a benefit of using application steering in SD-WAN?

The traffic always skips the regular policy routes.

You steer traffic based on the detected application.

You do not need to enable SSL inspection.

You do not need to configure firewall policies that accept the SD-WAN traffic.

NEW QUESTION 42
What are two benefits of using the Internet service database (ISDB) in an SD-WAN rule? (Choose two.)

The ISDB is dynamically updated and reduces administrative overhead.

The ISDB requires application control to maintain signatures and perform load balancing.

The ISDB applies rules to traffic from specific sources, based on application type.

The ISDB contains the IP addresses and port ranges of well-known internet services.

NEW QUESTION 43
Which two protocols in the IPsec suite are most used for authentication and encryption? (Choose two.)

Encapsulating Security Payload (ESP)

Secure Shell (SSH)

Internet Key Exchange (IKE)

Security Association (SA)

NEW QUESTION 44

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)

London generates an IKE information message that contains the Toronto public IP address.

Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.

Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.

The first packets from Toronto to London are routed through Hub 1 then to Hub 2.

NEW QUESTION 45
What is the route-tag setting in an SD-WAN rule used for?

To indicate the routes for health check probes.

To indicate the destination of a rule based on learned BGP prefixes.

To indicate the routes that can be used for routing SD-WAN traffic.

To indicate the members that can be used to route SD-WAN traffic.

NEW QUESTION 46
Refer to the exhibit.

An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.
Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)

The traffic matches a regular policy route configured with T_INET_1_0 as the outgoing device.

T_INET_1_0 has a lower route priority value (higher priority) than T_INET_0_0.

T_INET_0_0 does not have a valid route to the destination.

T_INET_1_0 has a higher member configuration priority than T_INET_0_0.

NEW QUESTION 47
Which diagnostic command can you use to show the configured SD-WAN zones and their assigned members?

diagnose sys sdwan zone

diagnose sys sdwan service

diagnose sys sdwan member

diagnose sys sdwan interface

Loading …

Fortinet NSE7_SDW-7.0 exam covers a wide range of topics, including SD-WAN deployment models, application identification, traffic management, security policies and troubleshooting. Candidates are required to demonstrate their knowledge of Fortinet’s SD-WAN solution, as well as their ability to apply this knowledge to real-world scenarios. NSE7_SDW-7.0 exam consists of multiple-choice questions and practical exercises, which test the candidate’s ability to configure and manage Fortinet’s SD-WAN solution.

NSE7_SDW-7.0 Free Exam Files Downloaded Instantly: https://www.passtestking.com/Fortinet/NSE7_SDW-7.0-practice-exam-dumps.html

Categories:NSE7_SDW-7.0Fortinet