[2023] Easy To Download DEA-5TT2 Actual Exam Dumps Resources [Q22-Q46]

Rate this post

[2023] Easy To Download DEA-5TT2 Actual Exam Dumps Resources

Uplift Your DEA-5TT2 Exam Marks With The Help of DEA-5TT2 Dumps

NEW QUESTION 22
What accurately describes OSPF?

Interior gateway link-state protocol

Exterior gateway distance-vector protocol

Interior gateway distance-vector protocol

Interior gateway path-vector protocol

NEW QUESTION 23
What are Network Address Translation (NAT) inside global addresses?

Addresses used by NAT router when sending frames to devices on the local network

Public IP addresses used by the local network to communicate with the Internet

Private IP addresses used by the local network

Pubic addresses used by other networks outside of the local network

NEW QUESTION 24
Refer to the exhibit.

Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2. Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?

Switch A Gi1/0/1

Switch A Gi1/0/2

Switch B Gi1/0/1

Switch B Gi1/0/2

NEW QUESTION 25
On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?

C9000 Series

N-Series

S-Series

Z-Series

NEW QUESTION 26
A network administrator created three VLANs on an Ethernet switch. How many broadcast domains are created by the switch?

NEW QUESTION 27
If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?

Multicast

Broadcast

Anycast

Unicast

NEW QUESTION 28
Which formula is used for calculating OSPF interface costs?

Reference bandwidth – interface bandwidth

Reference bandwidth / interface bandwidth

Reference bandwidth + interface bandwidth

Interface bandwidth / reference bandwidth

NEW QUESTION 29
Which port type should be used for only VLAN-unaware devices?

Access port

General port

Hybrid port

Trunk port

NEW QUESTION 30
In which Spanning Tree protocol state does a port record MAC addresses but does not forward the data?

Forwarding

Blocking

Learning

Listening

NEW QUESTION 31
Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?

Router

Repeater

Switch

NIC

NEW QUESTION 32
On which OSI layers do standard ACL filters operate?

2 and 3

2 and 7

3 and 4

4 and 7

NEW QUESTION 33
Which IEEE standard defines the Data Link Layer, Discovery protocol?

802.1AB

802.1AX

802.1D

802.1W

NEW QUESTION 34
What is the default OSPF “hello interval”?

5 seconds

10 seconds

15 seconds

30 seconds

NEW QUESTION 35
What is the valid range assigned to a client during a TCP connection?

20 – 25

443 – 1000

1023 – 2024

40000 – 65535

NEW QUESTION 36
Router A is directly connected to Router B over an Ethernet link. The local interface address for the Router A Fo0/48 interface is 144.254.32.2/24. Which routing table entry is visible on Router A?

144.254.0.0/16

144.254.0.0/24

144.254.32.0/24

144.254.32.2/24

NEW QUESTION 37
At which layer of the OSI model is the Rapid Spanning Tree protocol used to prevent switching loops?

Physical

Network

Data Link

Transport

NEW QUESTION 38
A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients.
Which IPv6 address prefix will the default gateway have on a client?

fd01::/64

fe08::/64

fe80::/64

ff02::/8

NEW QUESTION 39
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?

N1500 Series switch and N2000 Series switch

N1700 Series switch and N1500 Series switch

N1700 Series switch and N3500 Series switch

N3500 Series switch and N2000 Series switch

NEW QUESTION 40
Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?

MXL

M6220

M6348

M8024-K

NEW QUESTION 41
Which type of domains are connected by a Layer 2 switch?

Single collision domain and a single broadcast domain

Multiple broadcast domains and multiple collision domains

Multiple collision domains and a single broadcast domain

Single collision domain and multiple broadcast domains

NEW QUESTION 42
The IEEE separates the Data Link and Physical ISO layers into four sub-layers. Based on the exhibit, what is the correct order of these sub-layers; from lowest to highest?

NEW QUESTION 43
How many total addresses for network, broadcast, and host are provided with the subnet mask
255.255.255.240?

NEW QUESTION 44
Which option is used to configure Network Address Translation (NAT) to provide one-to-one mapping between local and global addresses?

Outside source static

Overload

Inside source static

PAT

NEW QUESTION 45
Which flags are used in the TCP header to initiate and end TCP connections or sessions?

Initiate = Acknowledge (ACK) End = Synchronize (SYN)

Initiate = Acknowledge (ACK) End = Finish (FIN)

Initiate = Synchronize (SYN) End = Finish (FIN)

Initiate = Finish (FIN) End = Synchronize (SYN)

Loading …