Updated PDF (New 2023) Actual Huawei H35-481_V2.0 Exam Questions [Q21-Q41]

Rate this post

Updated PDF (New 2023) Actual Huawei H35-481_V2.0 Exam Questions

Verified H35-481_V2.0 Exam Dumps PDF [2023] Access using PassTestking

The Huawei H35-481_V2.0 (HCIP-5G-RAN V2.0) Exam is a certification exam that validates the knowledge and skills of professionals in the field of 5G Radio Access Network (RAN). This exam is designed to test the understanding of candidates in various technical areas such as 5G RAN architecture, protocols, procedures, functions, and optimization. Professionals who pass this exam are certified as HCIP-5G-RAN V2.0, which is a globally recognized certification that demonstrates their ability to design, install, configure, and troubleshoot 5G RAN networks.

NO.21 In NSA networking, which of the following factors affect the downlink peak rate of a CPE?

Downlink transmit power of the NR base station

Uplink transmit power of the CPE

Downlink BLER of 3% or above

CPE location

NO.22 How many OM channels does a gNodeB support at most?

NO.23 If the configuration data of a new BTS5900 base station cannot be loaded remotely, which of the following can be used to for local data configuration?

Loading through the centralized maintenance system

Loading through the Web LMT

Loading through the MAE

Loading through the PnP mode

NO.24 Which of the following parameters In the NR MIB message indicates the time-domain position of CORESET 0?

System frame number

Most significant four bits of PDCCH-configSIBl

SSB-subcarrier offset

Least significant four bits of PDCCH-configSIBl

In 5G NR, the Master Information Block (MIB) message is transmitted on the Physical Broadcast Channel (PBCH) and contains information that is used by the UEs to synchronize to the cell and obtain basic system information. The parameters in the NR MIB message that indicate the time-domain position of CORESET 0 are the least significant four bits of PDCCH-configSIBl.

NO.25 The ESN of a gNodeB changes after the main control board Is replaced.

True

False

When the main control board of a gNodeB is replaced, the Equipment Serial Number (ESN) of the gNodeB also changes. The ESN is a unique identifier of the gNodeB that is programmed into the main control board and is used to identify the specific gNodeB in the network. So when the main control board is replaced, the ESN also changes.

NO.26 Which of the following scenario using the radio data planning file In the MAE-Deployment?

Configuration of parameters in multiple MOs

Batch reconfiguration of NEs

Reconfiguration of a single NE

Configuration of parameters in an MO

NO.27 User performance testing can be used to collect Information regarding low Internet access rate for a user. Which of the following information is not required to diagnose this issue?

BLER monitoring result

Downlink RSRP monitoring result

MCS count monitoring result

SCTP tracing result

SCTP tracing result is not required to diagnose a low Internet access rate for a user. User performance testing can be used to collect information such as BLER (Block Error Rate) monitoring result, downlink RSRP (Reference Signal Received Power) monitoring result, and MCS (Modulation and Coding Scheme) count monitoring result. However, SCTP (Stream Control Transmission Protocol) tracing result is not required to diagnose a low Internet access rate. Reference: https://www.aricent.com/blog/user-performance-testing-for-5g/
https://www.gsma.com/greater-china/wp-content/uploads/2021/02/5G-Use-Cases-for-Vertical-China-2021-EN.pdf
5G Use Cases for Vertical China – 2021
https://www.gsma.com/greater-china/wp-content/uploads/2021/02/5G-Use-Cases-for-Vertical-China-2021-EN.pdf
https://www.mdpi.com/2079-9292/10/24/3175
Smart Manufacturing and Tactile Internet Based on 5G in Industry …
https://www.mdpi.com/2079-9292/10/24/3175
https://www.cepal.org/sites/default/files/publication/files/46817/S2000960_en.pdf Digital technologies for a new future
https://www.cepal.org/sites/default/files/publication/files/46817/S2000960_en.pdf

NO.28 Which of the following methods can be used to locate faults on the user-plane path?

GTPU trace

Cell DT trace

SCTP tracing result

NG interface trace

NO.29 Unlike 4G base stations, 5G base stations do not need to be configured with tracking area Information.

True

False

Unlike 4G base stations, 5G base stations do need to be configured with tracking area Information. In 4G, tracking area information is used to identify the area where the mobile device is located and to control the paging process. In 5G, however, tracking area information is used to identify the area where the mobile device is located and to control the paging process as well as to manage the mobility of the mobile device in the 5G network. The tracking area information is also used for the initial registration of the mobile device and for handover between cells.

NO.30 Which of the following 5G technologies can be used to ensure the QoS and security of smart grid services?

5G super uplink

5G E2E slicing

5G carrier aggregation

5G DNN private line

NO.31 Which of the following parameters jointly identify the coverage area of an NRDUCELL?

NRCELUd

NrDuCellTrpId

NRDUCELUd

NrDuCellCoverageld

NO.32 One of the challenges of 5G network construction is to provide Indoor coverage in large stadiums, where Indoor interference severely affects network coverage and capacity. Which of the following solutions can effectively mitigate the interference caused by Indoor coverage with high-density site deployment?

High-power RRUs

Massive MIMO AAU

Multi-sector cell

Sector splitting

One of the challenges of 5G network construction is to provide Indoor coverage in large stadiums, where Indoor interference severely affects network coverage and capacity. One of the solutions that can effectively mitigate the interference caused by Indoor coverage with high-density site deployment is sector splitting. This solution involves dividing the cell into multiple smaller cells, each with its own set of antennas and RF parameters. By reducing the number of users and devices in each cell, sector splitting can significantly reduce the amount of interference and improve network coverage and capacity.

NO.33 Which of the following statements about PDSCH DMR5 is incorrect?

The start symbol of a front-loaded DMRS of a type B PDSCH is always the first symbol of PDSCH.

The front-loaded DMRS is mandatory, and the additional DMRS is optional.

The overhead of type 1 DMRS is less than that of type 2 DMRS.

The start symbol of a front-loaded DMRS of a type A PDSCH can be symbol 2.

NO.34 What does it mean when the RUN indicator of anAAU is blinking green (on for is and off for Is)?

There is power supply, but the board is faulty.

The board is working properly.

Software is being loaded to the board, or the board is not started.

There is no power supply, or the board is faulty.

NO.35 Which of the following 5G technologies can be used to ensure the QoS and security of smart grid services? (Choose One)

5G super uplink

5G E2E slicing

5G carrier aggregation

5G DNN private line

5G E2E slicing can be used to ensure the QoS and security of smart grid services. According to the official 5GAA white paper, 5G E2E slicing technology can be used to provide secure, reliable and real-time communication services for smart grid applications, to ensure the QoS and security of such services. Reference: https://www.5gaa.org/wp-content/uploads/2019/03/5G-AA-White-Paper-on-Smart-Grid.pdf
https://www.3gpp.org/ftp/tsg_ran/WG2_RL2/Specifications/202012_draft_specs_after_RAN_90/Draft_36300-fc0.docx
3GPP TS 36.300
https://www.3gpp.org/ftp/tsg_ran/WG2_RL2/Specifications/202012_draft_specs_after_RAN_90/Draft_36300-fc0.docx
https://www.etsi.org/deliver/etsi_tr/121900_121999/121915/15.00.00_60/tr_121915v150000p.pdf TR 121 915 – V15.0.0 – Digital cellular telecommunications system …
https://www.etsi.org/deliver/etsi_tr/121900_121999/121915/15.00.00_60/tr_121915v150000p.pdf
https://www.atis.org/wp-content/uploads/3gpp-documents/Rel16/ATIS.3GPP.38.473.V1620.pdf ATIS 3GPP
https://www.atis.org/wp-content/uploads/3gpp-documents/Rel16/ATIS.3GPP.38.473.V1620.pdf

NO.36 Which of the following MOs are involved in data reconfiguration using the MAE-Deployment?

gNodeBFuncrjon

gNBCULogicNode

gNBDULogicNode

gNodeBCUFunction

NO.37 Which of the following Information Is contained in a master Information block (MIB)?

System frame number

PDCCH ConfigSIB1

dmrs-TypeA-Position

Offset from PointA

In 5G NR, the master information block (MIB) is a control message that is transmitted by the base station on the Physical Broadcast Channel (PBCH). The MIB contains the following information:
1. System frame number: The MIB contains the system frame number (SFN) which is used to identify the current frame in the system.
2. PDCCH ConfigSIB1: The MIB contains the PDCCH (Physical Downlink Control Channel) configuration for the SIB1 (System Information Block 1) which is used to transmit system information to the UE.
3. dmrs-TypeA-Position: The MIB contains the position of the dmrs-TypeA (Diversity and Multiplexing Configuration Reference Signal) which is used to transmit a reference signal for demodulation and channel estimation.

NO.38 Which of the following Information Is contained in a master Information block (MIB)?

System frame number

PDCCH ConfigSIB1

dmrs-TypeA-Position

Offset from PointA

NO.39 Which of the following Information Is not carried In the DCI of NR?

PUSCH scheduling

PUSCH power control

PMI report

PDSCH scheduling

According to the official 3GPP specification, the DCI of NR does not carry PUSCH power control information. It carries scheduling information for the PUSCH and PDSCH and a PMI report. Reference: https://www.3gpp.org/DynaReport/38-series.htm

NO.40 Which of the following channels is not involved in NR random access of a UE?

PDCCH

PRACH

PU5CH

PUCCH

NO.41 In NSA networking, X2 self-setup between a gNodeB and an eNodeB requires that the gNodeB and eNodeB be managed by the same OSS.

True

False

Loading …