[Jun 05, 2022] Download Free Network Appliance NS0-520 Real Exam Questions [Q99-Q114]

Rate this post

[Jun 05, 2022] Download Free Network Appliance NS0-520 Real Exam Questions

Pass Your Exam With 100% Verified NS0-520 Exam Questions

NO.99 An additional LUN is required to be created and attached to an existing VMware ESXi environment. You are asked by a VMware administrator what NetApp software would validate multi-path connections to a newly presented FC LUN.
In this scenario, which NetApp software is required?

 
 
 
 

NO.100 Which resource would you use to verify whether a specific SAN configuration is supported by NetApp?

 
 
 
 

NO.101 You have a two node Netapp ONTAP cluster that is hosting FC LUNs for 90 SAN hosts. The hosts are experiencing occasional performance problems and receiving QFULL responses from the cluster nodes. Which action would solve this issue?

 
 
 
 

NO.102 A customer wants to add a 2-port, 32 Gb FC card to support NVMe in an AFF A700 2-node cluster. Currently, there are cards in slots 1, 2, 4, 6, 8, and 9.
Referring to the exhibit, what is the number of the slot that should be used?

 
 
 
 

NO.103 During testing, an administrator notices that the wrong subsystem was returned using the NVMe discover command. The administrator was expecting test0_subsystem as the subsystem Referring to the exhibit, what would cause the discrepancy?

 
 
 
 

NO.104 At which storage object level is deduplication enabled?

 
 
 
 

NO.105 A customer has an existing 8-node cluster that consists of six FAS2650 nodes and two FAS2554 nodes. The customer wants to expand the cluster by adding two AFF A220 nodes.
Which resource would be used to determine whether this configuration is supported?

 
 
 
 

NO.106 What is the default Ethernet packet size (or MTU – Maximum Transmission Unit) for Ethernet ports on Ethernet switches?

 
 
 
 

NO.107 Exhibit.

A customer is testing a dual-fabric FC SAN configuration as shown in the exhibit. The zones are implemented on the switches shown below.

IF all the nodes are in the SLM reporting nodes list, how many paths per LUN should the customer expect when simulating a node failure by powering off Node 04?

 
 
 
 

NO.108 Click the Exhibit button.

An administrator has added two nodes to an existing cluster. The administrator created the svfc2 SVM to use FC to present LUNs to hosts. The hosts are unable to see the LUNs that have been presented to them.
Referring to the exhibit, what is the problem?

 
 
 
 

NO.109 Exhibit.

The exhibit shows the Inn show command output for the oradata oraFinProd_l LUN.
Which two statements ate correct about the LUN’? (Choose two.)

 
 
 
 

NO.110 Referring to the exhibit, which two LIFs would be optimized paths to LUN /vol/OraDev_Vol/OraDev? (Choose two.)

 
 
 
 

NO.111 When booting your NetApp storage system for the first time the system fails to boot.
What should you do first to address this problem?

 
 
 
 

NO.112 An administrator wants to design an NVMe solution to connect Linux hosts to an ONTAP cluster. The proposed solution uses two Cisco MDS 9396T switches for each fabric in a top-of-rack design.
In this scenario, which statement is true?

 
 
 
 

NO.113 Click the Exhibit button.

You have three Linux hosts that are FC multipath connected to an AFF All SAN Array A700. A failover test is performed by shutting down both Fabric A and N2, as shown in the exhibit.
Referring to this exhibit, what happens to the remaining paths from the Linux hosts to the ASA A700 target?

 
 
 
 

NO.114 A customer is using both FC and NVMe in a cluster. The customer needs to do some work on AFF_1.
Referring to the exhibit, what will happen?

 
 
 
 

NetApp NS0-520 Exam Topics:

Section Objectives
ONTAP® SAN solution assessment – Identify that all prerequisites for the installation of NetApp® system, hosts, and FCP/FCoE switches are verified.
– Identify a detailed inventory of SAN components
– Describe the solution design and the hardware provisioned to meet customer’s requirements and expectations.
ONTAP SAN implementation and configuration – Demonstrate knowledge of clustered storage system node configuration tasks
– Demonstrate knowledge of SVM configuration tasks
– Demonstrate knowledge of clustered storage system FCP or NVMe configuration tasks
– Demonstrate knowledge of clustered storage system iSCSI configuration tasks
– Describe how to configure switches
– Describe how to configure host systems
– Demonstrate knowledge of storage space utilization or management concepts
ONTAP SAN planning – Identify environmental and physical considerations
– Describe storage controller configuration concepts
– Describe switch configuration concepts
– Describe host configuration concepts
– Describe storage space utilization or management concepts
ONTAP SAN implementation testing and troubleshooting – Demonstrate knowledge of testing tasks
– Demonstrate knowledge of troubleshooting tasks

 

NS0-520 Dumps 100 Pass Guarantee With Latest Demo: https://www.passtestking.com/NetworkAppliance/NS0-520-practice-exam-dumps.html

admin

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter the text from the image below
 

Post comment