JNCIS-SP JN0-363연습문제집 265개 시험 문제 [Q157-Q177]를 시험해 보세요.

질문 157
Which statement is true when using MVRP on MX Series devices?

질문 158
What is required on the egress and ingress devices to transport IPv6 traffic across an IPv4 network?

질문 159
Referring to the exhibit, you have configured an aggregate route that represents the 172.21.0.0/24, 172.21.1.0/24, and 172.21.2.0/24 networks. However, when you view the routing table, your new route hidden.
Which action would you perform to determine the problem?

질문 160
전시 버튼을 클릭합니다.

Referring to the exhibit, how many milliseconds must pass before the interface ge-0/0/1.0 is considered down?

질문 161
Before configuring an RSVP LSP in your network, you first apply a baseline configuration to all of the routers.Which three configuration elements are minimally required in the baseline? (Choose three.)

질문 162
전시회를 클릭합니다.


You are using OSPF as your IGP in your network. You have applied the OSPF configuration shown in the exhibit to router R1.
다음 중 이 시나리오에 해당하는 것은 어느 것입니까?

질문 163
Which three statements are true about GRES? (Choose three.)

질문 164
You are deploying an RSVP-based MPLS network in your core. You must ensure that your LSPs are continually analyzing the usage levels and recalculating the best LSP. You also want to ensure that a minimal amount of traffic is lost when an LSP is re-signaled without user intervention.
Which two features must be enabled in this scenario? (Choose two.)

질문 165
전시회를 클릭합니다.

On an MX Series device, you must enable routing between VLANs 100,200, and the Internet ge-5/1/0, and ge-5/1/2 are bundled into interface ae3. Ge-5/1/4, and ge-5/1/5 are bundles into interface ae2. Both AE bundles trunk VLANs 100 and 200.
In this scenario, what is the correct configuration snippet for VLAN 100?

질문 166
경로 계산에 OSPF 링크 상태 데이터베이스를 사용하는 LSP를 구성하라는 요청을 받았습니다. 이 시나리오에서 올바른 두 문장은 다음 중 어느 것입니까? (두 개를 선택하십시오.)

질문 167
In your RSVP network you have configured three separate LSPs to the same egress address. You have made no other configuration changes to the forwarding decisions made by the router.Which commands can you use to determine which LSP is being used to forward packets?

질문 168
전시회를 클릭합니다.

You are asked to enable a new BGP connection on R1, which has an existing IPv4 peering with R2. The new peering with R3 will use IPv6.
Referring to the exhibit, which two steps are required to enable the new IPv6 peering? (Choose two.)

질문 169
전시회를 클릭합니다.

Your network consists of subnets shown in the exhibit. You are asked to create an aggregate route for Router 1.
What is the appropriate prefix for the aggregate route in this scenario?

질문 170
You own a small company and need to assign IPv6 addresses to your routers. Because you want to follow the guidelines spelled out in RFC 3177, you want to design your network with the correct prefixes.Which prefix would your ISP likely allocate to your company?

질문 171
전시회를 클릭합니다.

The router with the configuration shown in the exhibit has two interfaces, both of which are operational and can pass traffic. These interfaces are connected to two different routers, both of which are configured for OSPF area 0.0.0.1. The router has received LSAs and can now send traffic into the backbone area.
다음 중 정답은 어느 것입니까? (두 개를 선택하세요.)

질문 172
You want the R1 and R3 routers to forward traffic destined to the 203.0.113.0/24 network through R2. Which BGP attribute would you modify to satisfy this requirement?

질문 173
Router A receives two similar route advertisements from different BGP peers.What would cause a route to be selected in this scenario?

질문 174
Referring to the exhibit, which firewall filter action(s) will be applied to incoming frames to ge-1/0/3?

질문 175
전시 버튼을 클릭합니다.

전시회를 참조하여 다음 중 사실인 것은 어느 것입니까? (두 개를 선택하십시오.)

질문 176
전시회를 클릭합니다.


You have just configured a GRE tunnel, but you notice that the GRE tunnel is flapping.
Referring to the exhibit, which two would you take to solve this problem? (Choose two.)

질문 177
You are setting up a new IS-IS adjacency between two devices. The new Level1 adjacency is not establishing.
What would cause this behavior?