[Jul-2026] Valid Way To Pass Huawei Exam Dumps with H35-210_V2.5 Exam Study Guide [Q82-Q105]

이 게시물 평가하기

[Jul-2026] Valid Way To Pass Huawei Exam Dumps with H35-210_V2.5 Exam Study Guide

All H35-210_V2.5 Dumps and HCIA-Access V2.5 Training Courses Help candidates to study and pass the Exams hassle-free!

The H35-210_V2.5 exam is designed to test the candidate’s knowledge and skills in a wide range of network access technologies, including network access security, network access control, WLAN technology, and network access management. H35-210_V2.5 exam is divided into two parts, the theoretical part and the practical part. The theoretical part covers the basic concepts and principles of network access technologies, while the practical part tests the candidate’s ability to apply their knowledge in real-world scenarios.

NO.82 Which of the following boards does not belong to the narrowband service board of the UA5000?

A32

A64

DSLD

ADRI

NO.83 According to whether the UA2000 alarm is confirmed and cleared, what are its alarm states?

Unconfirmed and uncleared

Confirmed but not cleared

Unconfirmed and cleared

Confirmed and cleared

NO.84 When the Access port of the Ethernet switch receives a packet with a tag, which of the following processing behavior is correct?

When the VLANID is the same as the default VLANID, the packet is received.

Strip the frame’s PVID Tag first, and then receive it.

When the VLANID is different from the default VLANID, the packet is received.

Receive the message and tag it with the default VAN.

NO.85 What are the management protocols running between the OLT and the ONT in the GPON network?

HGMP

OAM

OMCI

DHCP

NO.86 All H.248 commands require the receiver to send back a response.
Which of the following messages can be used to respond?

pending

ack

완료

NO.87 The MA5600 main control board (SCU) restarts repeatedly. What are the reasons why it is impossible?

Main control board host software problem

Incorrect data configuration

User ring network problem

The main control board component is damaged

NO.88 For multiple static routes reaching the same destination, you can configure different priorities for them, so as to more flexibly apply route management policies to achieve route backup. This static routing scheme is called

Floating Static Routes

Static routes are permanently published

Static Route Load Balancing

Default static route

NO.89 Regarding OLT+MDU networking and OLT+ONT networking, what are the correct statements about multicast configuration?

The configuration of the two on the OLT is the same.

When the unicast VLAN and the multicast VLAN are different, the configuration of the two on the OLT is the same.

When the unicast VLAN and the multicast VLAN are different, under the OLT+MDU networking, an additional gemport-maping and service-port for the multicast VLAN on the MDU should be added on the OLT.

위의 항목에 해당하지 않음

NO.90 Which of the following are the advantages of PON access technology? (Multiple choice)

Low fiber loss and wide coverage

Large bandwidth and good scalability

OPEX is low

Save main thousand optical fibers and optical modules

NO.91 Regarding the description of UA5000, which of the following statements is wrong?

UA5000 adopts the same hardware platform and supports the integration of PSTN, NGN, IMS and FTTx.

UA5000 supports various traditional private line services under TDM/PSTN.

UA5000 supports ADSL2+ service access.

The UA5000 does not support VDSL2 service access temporarily.

NO.92 Which of the following statements about GPON is incorrect?

Each GPON port supports a split ratio of 1:64, which can provide 64 ONT access.

There can be multiple T-CONTs on each ONU, and multiple GEMPORTs can be bound to each TCONT.

T-CONT is equivalent to a physical cache, and the rate can be limited only if it is bound to a DBA template.

ONU ID must be unique on the OLT

NO.93 Is the following description correct? When the MA5680T is configured with multicast services, the unicast VLAN carrying the multicast services must be consistent with the multicast VLAN.

True

False

NO.94 Regarding multicast and IPTV, which of the following statements is incorrect?

Multicast refers to the form of point-to-multipoint communication in the network

The core of multicast technology is to place the message copy work as close as possible to the receiver to complete it, reducing the data traffic on the network.

Through the introduction of controlled multicast, the management and control of multicast users are completed on the DSLAM equipment,

IPTV is a way of video on demand

NO.95 Which of the following statements about static route configuration is correct?

The preference is mandatory.

The next hop is mandatory.

The mask parameter is optional.

The mask parameter is mandatory.

When configuring a static route, certain parameters are required for the route to function correctly.
Let us analyze each option:
Option A:
Incorrect: The preference (or administrative distance) is optional. If not specified, the router uses the default preference value for static routes.
Option B:
Incorrect: While the next-hop IP address is commonly used in static route configuration, it is not always mandatory. For example, you can specify an outgoing interface instead of a next-hop address.
Option C:
Incorrect: The subnet mask is essential for defining the network prefix of the destination network.
Without the mask, the router cannot determine the range of IP addresses covered by the route.
Option D:
Correct: The subnet mask is mandatory when configuring a static route. It defines the network portion of the destination IP address, enabling the router to match packets to the correct route.
Thus, the correct answer is D.

NO.96 The routing table of a router contains the following two entries:
Destination/Mask Protocol Pre Cost Nexthop Interface
9.0.0.0/8 OSPF 10 50 1.1.1.1 Serial0
9.1.0.0/16 RIP 100 5 2.2.2.2 Ethernet0
If the router needs to forward packets with the destination address of 9.1.4.5, which of the following statements is correct?

The router selects the first route, because the priority of OSPF is higher.

The router selects the second route, because this route matches the destination address 9.1.4.5 more accurately.

The router selects the second route, because the metric of RIP is smaller.

The router selects the second route, because the outbound interface is Ethernet0, which is faster than Serial0.

When a router forwards packets, it selects the route with the longest prefix match (most specific route) for the destination address.
First Route: Matches 9.0.0.0/8, which covers all IP addresses starting with 9.
Second Route: Matches 9.1.0.0/16, which is more specific and covers IP addresses starting with
9.1.
For the destination address 9.1.4.5 , the second route (9.1.0.0/16) is a better match because it is more specific than the first route (9.0.0.0/8).
Option A: Incorrect. OSPF has a higher priority, but the longest prefix match takes precedence over priority.
Option B: Correct. The second route matches the destination address more accurately.
Option C: Incorrect. Metric is not considered when comparing routes with different prefix lengths.
Option D: Incorrect. Interface speed is irrelevant in route selection.

NO.97 Is the following description correct? The idea of the FTTx device offline deployment plan is to generate offline device configuration data through network planning dat a. After the device is installed and powered on, the configuration data is automatically issued to achieve the purpose of plug-and-play equipment.

True

False

NO.98 Which of the following statements about XGS-PON data transmission are incorrect? (Select All that Apply)

Each service/user must use different GEM port channels.

GEM ports in a T-CONT cannot exceed twice the number of users.

All services can be carried by the same T-CONT.

Data in the same GEM port can be received by only one ONU.

NO.99 Which of the following statements about MIB is incorrect?

The MIB information of a device can be read using the MIB BROWSER tool.

MIB is an important part of the SNMP network management model.

The OID in a MIB is usually identified by a group of letters.

MIB is short for management information library.

OIDs (Object Identifiers) are numeric (e.g., 1.3.6.1.2.1.1.5), not letters. The statement in C is incorrect.

NO.100 Which of the following statements about DHCP is wrong?

Multiple DHCP servers are not allowed in the network at the same time, because multiple servers will respond at the same time, and the client cannot choose an address

The Discover message between the DHCP Relay and the DHCP server is a unicast message

If the client gives up the current IP address, uses the DHCPRELEASE message to notify the server, and the server reclaims this address for the next use.

The packet exchanges experienced by DHCP to obtain an address normally include Discover,offer, Request and ACK

NO.101 The FTP, TFTP, or SFTP mode can be used to transfer files during the upgrade of the access network. The FTP mode is recommended.

TRUE

FALSE

NO.102 Which of the following is the downstream wavelength of XGS-PON?

1490 nm

1310 nm

1577 nm

1290 nm

* XGS-PON Wavelengths :
* XGS-PON (10-Gigabit Symmetric Passive Optical Network) uses specific wavelengths for upstream and downstream transmission:
* Downstream (OLT to ONU) : 1577 nm.
* Upstream (ONU to OLT) : 1270 nm.
* Why 1577 nm?
* The ITU-T G.9807.1 standard specifies 1577 nm as the downstream wavelength for XGS-PON.
This wavelength is chosen to avoid interference with GPON, which uses 1490 nm for downstream transmission.
* Other Options :
* 1490 nm : Used for downstream transmission in GPON, not XGS-PON.
* 1310 nm : Used for upstream transmission in GPON, not XGS-PON.
* 1290 nm : Not a standard wavelength in PON technologies.
Thus, the correct answer is C .
참조:
* HCIA Huawei ACCESS Official Documentation , Chapter: XGS-PON Wavelengths.
* ITU-T G.9807.1 Standards for XGS-PON .

NO.103 What protocol does the FTP protocol run on?

UDP

TCP

ARP

NO.104 Which message does GPON transmit by establishing a dedicated ATM PVC or GEM Port between OLT and ONT? Used to provide standard discovery ONU capabilities, and to manage and control them.

PLOAM

MPCP

DBAs

OMCI

NO.105 When the MA5600T/MA5603T equipment needs to be maintained and managed locally, the baud rate setting of the maintenance terminal’s HyperTerminal must be consistent with the serial port baud rate parameters of the MA5600T/MA5603T system.
What is the system default serial port baud rate?

9600bit/s

19200bit/s

38400bit/s

115200bit/s

로드 중 …

Huawei H35-210_V2.5 exam is a comprehensive test that measures an individual’s proficiency in various aspects of network access technologies. Candidates who pass H35-210_V2.5 exam are equipped with the necessary skills and knowledge to design, deploy, and manage network access solutions in a variety of settings, from small and medium-sized businesses to large enterprises.

Get Latest [Jul-2026] Conduct effective penetration tests using PassTestking H35-210_V2.5: https://www.passtestking.com/Huawei/H35-210_V2.5-practice-exam-dumps.html

카테고리:H35-210_V2.5Huawei